Crawling of hydraulic presses poses great harm, damaging the surface quality (roughness) and machining accuracy of hydraulic equipment, reducing the service life of hydraulic machine tools and cutting tools, and even producing waste and accidents. Therefore, it must be ruled out.
The executing components of hydraulic press equipment (hydraulic cylinders or hydraulic motors) often require very low speeds, such as moving a few millimeters or even less than 1mm per minute or rotating a few revolutions per minute. At this time, there is often a noticeable uneven speed, intermittent intermittent movement and stopping, one fast and one slow, one jump and one stop phenomenon, which becomes a problem with the low-speed stability of hydraulic presses. The minimum speed at which crawling does not occur is called the critical speed for motion stability.
The same type of crawling has different fault phenomena: regular crawling and irregular crawling; Some crawls are irregular and have large amplitudes; Some crawls occur at extremely low speeds. The crawling that causes these different phenomena has different reasons and focuses: some are mainly caused by mechanical reasons, some are mainly caused by hydraulic reasons, some are mainly caused by air entering the oil, and some are mainly caused by poor lubrication. The maintenance and operation of hydraulic equipment in hydraulic presses require maintenance personnel to constantly summarize and quickly identify the causes of crawling and eliminate them. To solve the problem of hydraulic press crawling, we should start from the following aspects. Focus on solving the friction state of moving parts and the balance of machine motion:
1) The precision of the guide rail is poor, and the guide rail surface (V-shaped, flat guide rail) is severely twisted.
2) There are rust spots on the guide rail surface.
3) The clamping strip of the guide rail pressure plate is adjusted too tightly, resulting in significant differences in the dynamic and static friction coefficients of the guide rail material.
4) Poor scraping and grinding of the guide rail, insufficient number of points, and uneven points.
5) The oil groove opened on the guide rail is not good, the depth is too shallow, and it has been worn off during operation. The oil groove opened is uneven, and the length of the oil groove is too short.
6) The hydraulic equipment of the new hydraulic press does not have the guide rail running in.
7) The axis of the hydraulic cylinder on the hydraulic press is not parallel to the guide rail.
8) Rust (localized crawling) and strain on the arresting section of the hydraulic cylinder block hole on the hydraulic press.
9) The hydraulic cylinder holes, piston rods, and pistons on hydraulic presses have poor accuracy
10) The hydraulic cylinder on the hydraulic press has poor installation accuracy, and the coaxiality of the piston, piston rod, cylinder body hole, and cylinder cover hole is poor.
11) Hydraulic cylinder piston or cylinder head seal is too tight, blocked, or too loose.
12) Excessive downtime and moisture in the oil (especially in the coolant of the grinding machine) can cause rusting in some parts.
13) The static pressure guide rail throttle is blocked, causing the guide rail to cut off oil.
Jun 01, 2024
Leave a message
Analysis Of The Causes Of Hydraulic Press Crawling Phenomenon
Next
No InformationSend Inquiry





